N-Tron Switch 708M12 User Manual download pdf (Page 67)

Revision 071108

Page 67 of 102

Configuration – Save or Reset

The Configuration section of web management gives an administrator the ability to save a running

configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a

power cycle.

The “Save” button will save all current changes to the configuration for use after the next power cycle.

Note: The current configuration will also be saved to the dongle when connected.

The “Reset” button will discard all unsaved changes, reset the switch and load the most recently saved

configuration settings. Note: Upon restart, if a configured dongle is connected, the switch will load the

configured settings from it and save them into NVRAM.

The “Factory” button will reload N-Tron’s factory default configuration settings. Doing so will reconfigure

the 700 Series switch to factory defaults. In many cases it is desirable to restore factory defaults but retain

the IP address, subnet mask, and gateway address settings as well as user names and passwords.

Checkboxes are provided to select the desired behavior. Note: The factory default configuration settings

will also be saved to the dongle when connected.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 101 102

No comments

N-Tron Switch 708M12 User Manual Page 67