N-Tron 900 User Manual

900 Series Industrial Ethernet Switch Installation & User’s Guide

4/26/2007 10 MODULE CONFIGURATION SETTINGS In order for the 900 Series modules to communicate properly the chassis must be populated with modules fro

4/26/2007 11 908TX Module From Left to Right: RJ45 Ports Ports 1-8 Auto sensing 10/100BaseT Ports Upper Left LED Port Link Status Upper Righ

4/26/2007 12 902/904 FX & FXE Module From Left to Right: TX Fiber Optic Transmit Port RX Fiber Optic Receive Port LNK Link LED (top LED)

4/26/2007 13 APPLYING POWER 1. Unscrew the flange & Remove the DC Voltage Input Plug(s) from the side headers. 2. Install the DC Power Cables

4/26/2007 14 N-TRON SWITCH GROUNDING TECHNIQUES The grounding philosophy of any control system is an integral part of the design. N-Tron switches ar

4/26/2007 15 CONNECTING THE UNIT For 902 & 904 FX & FXE units, remove the dust cap from the fiber optic connectors and connect the fiber op

4/26/2007 16 Key Specifications Physical Height: 3.2" (8.13 cm) Width: 7.1" (18.03 cm) Depth: 4.1" (10.41 cm) Weight:

4/26/2007 17 Regulatory Approvals: Safety: UL 1604 (US and Canada) Hazardous Locations, Class I, Zone 2, Group IIC, T4A EMI: EN50081-1:1992, EN550

4/26/2007 18 N-TRON Limited Warranty N-TRON, Corp. warrants to the end user that this hardware product will be free from defects in workmanship and m

4/26/2007 2 Industrial Ethernet Switch Installation Guide 900B/900N (3 Slot Enclosure and Backplane) 900B-FP (Filler Panel for empty slots) 908TX (M

4/26/2007 3 Copyright, © N-TRON Corp., 2006 N-TRON Corp. 820 S. University Blvd., Suite 4E Mobile, AL 36609 All rights reserved. Reproduction, a

4/26/2007 4 Safety Warnings ELECTRICAL SAFETY WARNING: Disconnect the power cable before removing the enclosure top. WARNING: Do not operate the

4/26/2007 5 900 Series Hazardous Location Installation Requirements 1. WARNING: EXPLOSION HAZARD. DO NOT DISCONNECT UNIT WHILE CIRCUIT IS

4/26/2007 6 900 Series Industrial Ethernet Switches The 900 Series Modular Industrial Ethernet Switches support high speed layer 2 switching between

4/26/2007 7 PACKAGE CONTENTS Please make sure the Ethernet Switch package contains the following items: 1. 900 Series Ethernet Switch 2. Installe

4/26/2007 8 902FX/FXE & 904FX /FXE HALF DUPLEX SETUP All 900 series fiber modules are factory configured for full duplex operation. The setting

4/26/2007 9 DIN-Rail Mounting Install the unit in a standard DIN-Rail. Recess the unit to allow at least 5” of horizontal clearance for fiber optic